Xerox Versant 4100 Press, User Documentation

Page: 315 / 430

• Transfer defects may occur when paper speed is too fast or too slow.
3. Change the Fuser Speed Adjustment setting.
• This feature can be used to correct the issue of a smear at 208 mm from the Lead Edge (LE).
Increase the fuser speed to correct the issue.
• This feature also impacts print quality.
– Increasing fuser speed extends the image. If fuser speed is set too high it may cause
paper jams.
– Decreasing fuser speed shrinks the image.
• The option can be found in PredictPrint Media Manager → Stock Library → Stock
Properties → Advanced Setup → Fuser Speed Adjustment .
• Increase fuser speed in increments of 0.5%. After every increment adjustment run test prints
and evaluate the output to determine if additional adjustment is necessary.
TTrraaiill EEddggee D Deelleettiioonnss
For information, refer to the Advanced Stock Setup .
Problem
The printed output contains trail edge deletions.
Solutions
Change the Transfer Output Adjustment for Trail Edge setting.
• This feature is used to adjust the voltage ratio on the Secondary Bias Transfer Roll (BTR), where
the image is transferred from the belt to the paper.
• This feature can be found in PredictPrint Media Manager → Stock Library → Stock
Properties → Advanced Setup → Transfer Output Adjustment for Trail Edge .
• Decrease the Transfer Output Adjustment for Trail Edge in increments of 5 to 10%. After every
increment adjustment run test prints and evaluate the output to determine if additional
adjustment is necessary.
PPrreeddiiccttPPrriinntt M Meeddiiaa M Maannaaggeerr D Deeffaauulltt SSeettttiinnggss
The following information provides the default values, ranges, and recommended incremental
adjustments for the various
PredictPrint Media Manager
features, options, and settings.
Xerox ® Versant ® 4100 Press
User Documentation
315
Troubleshooting