• Transfer defects may occur when paper speed is too fast or too slow.
3. Change the
Adjust Fusing Speed
setting.
• This feature can be used to correct the issue of a smear at 208 mm from the Lead Edge (LE).
Increase the fuser speed to correct the issue.
• This feature also impacts print quality.
–
Increasing fuser speed extends the image. If fuser speed is set too high, paper jams can
occur.
–
Decreasing fuser speed shrinks the image.
• The option can be found in
Machine Status
→
Tools
→
Setup & Adjustment
→
Custom Paper
Settings
. Select the desired
Custom Paper
→
Change Settings
→
Adjust Fusing
Speed
→
Change Settings
.
• Increase fuser speed in increments of 0.5%. After every increment adjustment run test prints
and evaluate the output to determine if additional adjustment is necessary.
TTrraaiill EEddggee D
Deelleettiioonnss
Problem
The printed output contains trail edge deletions.
Solutions
Change the
Adjust Image Transfer for Trail Edge
setting.
• This feature is used to adjust the voltage ratio on the Secondary Bias Transfer Roll (BTR), where
the image is transferred from the belt to the paper.
• This feature can be found in
Machine Status
→
Tools
→
Setup & Adjustment
→
Custom Paper
Settings
. Select the desired
Custom Paper
→
Change Settings
→
Adjust Image Transfer for Trail
Edge
→
Change Settings
.
• Decrease the
Adjust Image Transfer for Trail Edge
in increments of 5%–10%. After every
increment adjustment run test prints and evaluate the output to determine if additional
adjustment is necessary.
C
Cuussttoom
m PPaappeerr SSeettttiinnggss -- D
Deeffaauulltt SSeettttiinnggss
The information provides the default values, ranges, and recommended incremental adjustments for
the various Custom Paper Settings features, options, and settings.
261
