7 Center Front Door
Open this door to access the decurler area and fuser assembly.
8 Right Front Door
Open this Output Module door to access the exit/inverter area, the cooling belt and
full width array.
9 Paper Trays 1, 2, and 3
These internal trays of the print engine feed standard size paper.
10 Offset Catch Tray (OCT)
If there are no inline finishing devices attached to the system, the Offset Catch Tray
can be installed for holding print output.
The Interface Module (11) and optional finishing devices such as the High Capacity
Stacker (12) are not part of the base configuration. When the Offset Catch Tray is
removed, and any of the optional finishing devices are attached, the Interface Module
is required to provide decurling and paper height adjustment between the print engine
and the attached finishing device.
Locating the Press Serial Number
The press serial number can be accessed from either the press control panel or by locating
the serial number plate on the inside frame of the first feeder tray (Tray 1).
1. Press the Machine Status button on the press control panel.
2. From the Machine Status screen, ensure that the Machine Information tab is
displayed.
The press serial number is displayed under General Information.
3. If there is a loss of power and it is not possible to access the Machine Status screen,
the press serial number can also be found on the inside frame of the press near the
Paper Tray 1 drawer:
a) At the press, fully open Paper Tray 1.
b) At the left of the feeder tray, on the press frame, locate the plate with the serial
number (SER#).
1-3
Xerox
®
Versant™ 2100 Press
Quick Start Guide
Product Overview
