A screen message advises of a short wait while the fuser warms up and the press runs
a system check. You can set features for a job during this time and the printing process
will start automatically when the press is ready.
To switch off the press:
• Press the Power On/Off button on the print engine.
Note
Allow the press to remain off for a minimum of 10 seconds before switching on the
power again.
Feeding and Finishing Devices
Available with your press is a variety of optional feeding and finishing devices.
Note
for more information on the optional
feeding and finishing devices.
Calling for Service
1. Record any displayed fault codes.
2. Record the press serial number. To access, select the Machine Status button at the
press Control Panel. From the Machine Status screen, select the Machine Information
tab to view the serial number listed. If the serial number is not displayed, open the
press Paper Tray 1 drawer and locate the serial number plate on the left side of the
frame (SER #).
3. If output quality is a problem, take a sample as a reference to assist you in describing
the problem over the telephone when answering the questions from the customer
support operator about the defects.
4. If possible, use a phone near the press when calling for assistance. Follow the
instructions provided by the operator.
5. For system support, user help, and service support, call the appropriate number. For
the specific number in your area, go to
and select the Support link.
Xerox
®
Versant™ 2100 Press
1-8
Quick Start Guide
Product Overview
