Xerox VersaLink B605, User Manual, Page: 245 / 273

To enable Auto Power Off mode, contact your System Administrator. For details, refer to the System
Administrator Guide at www.xerox.com/office/VLB605_VLB615docs .
To learn more about Xerox participation in sustainability initiatives, go to: www.xerox.com/about-
xerox/environment/enus.html .
Note: Changing the default Power Saver activation times can result in an overall higher energy
consumption of the device. Before you turn off Power Saver modes or set a long activation
time, consider the increase in device power consumption.
D Deeffaauulltt PPoow weerr SSaavveerr SSeettttiinnggss
This device is ENERGY STAR ® -qualified under the ENERGY STAR Program Requirements for Imaging
Equipment. The transition time from Ready mode to Low-Power mode can be set up to 60 minutes.
The default value is 5 minutes. The transition time from Low-Power mode to Sleep mode can be set
up to 60 minutes. The default value is set at 1 minute. The total transition time from Ready mode to
Sleep mode can take up to 60 minutes.
To change the Power Saver settings, contact your System Administrator, or refer to the System
Administrator Guide at www.xerox.com/office/VLB605_VLB615docs .
EEnnvviirroonnm meennttaall B Beenneeffiittss ooff D Duupplleexx PPrriinnttiinngg
Most Xerox products have duplex printing, also known as 2-sided printing, capability. This enables you
to print on both sides of the paper automatically, and therefore helps to reduce the use of valuable
resources by reducing your paper consumption. The Lot 4 Imaging Equipment agreement requires
that on models greater than or equal to 40 ppm color or greater than or equal to 45 ppm
monochrome the duplex function has been auto-enabled, during the setup and driver installation.
Some Xerox models below these speed bands may also be enabled with 2-sided printing settings
defaulted on at the time of install. Continuing to use the duplex function will reduce the
environmental impact of your work. However, should you require simplex/1-sided printing, you may
change the print settings in the print driver.
PPaappeerr TTyyppeess
This product can be used to print on both recycled and virgin paper, approved to an environmental
stewardship scheme, which complies with EN12281 or a similar quality standard. Lighter weight
paper (60 g/m²), which contains less raw material and thus saves resources per print, may be used in
certain applications. We encourage you to check if this is suitable for your printing needs.
RReegguullaattoorryy IInnffoorrm maattiioonn ffoorr 22..44--G GH Hzz aanndd 55--G GH Hzz
W Wiirreelleessss N Neettw woorrkk A Addaapptteerrss
This product contains a 2.4-GHz and 5-GHz Wireless LAN radio transmitter module that complies with
the requirements specified in FCC Part 15, Industry Canada RSS-210, and European Council Directive
2014/53/EU. Radio Frequency (RF) output power of this device will not exceed 20 dBm in either
frequency band.
Operation of this device is subject to the following two conditions:
Xerox ® VersaLink ® B605/B615 Multifunction Printer
User Guide
245
Regulatory Information