Xerox Phaser EX7750, Configuration Manual

Page: 84 / 220

4
4-24 Performing Setup from the Control Panel
Clear Frame Types
You can clear all frame types at once by choosing Exit IPX/SPX Setup, choosing
IPX/SPX Setup, and then choosing Clear Frame Types.
Service Setup options
PServer is a program in the EX7750 software that can service the Novell Print queues
assigned to the Novell print servers you have set up for printing to the EX7750. When
you choose PServer Setup and enable PServer, you can set up NDS (Novell Directory
Services), Bindery Services, or both. NDS is used with NetWare; Bindery Services are
used with NetWare in bindery emulation mode.
Select Frame Types
Enable IPX Auto Frame Type
Yes/No [No]
Specify whether the EX7750 should try to bind to all available frame types
automatically. The EX7750 does so whether or not all frame types are appropriate. To
determine the frame types that were successfully bound, save your changes, exit Setup,
restart the EX7750, and print a Configuration page. The Configuration page lists only
one of the frame types that were successfully bound.
If you answer No to this option, you can select frame types manually. You must choose
at least one frame type to enable IPX/SPX protocols.
The frame selection screen allows you to make multiple selections. Depending on your
Port Setup selection, only Ethernet frame types, or all frame types are displayed.
Press the line selection button beside each frame type used on your IPX/SPX network.
An asterisk (*) appears beside each selected frame type. Press the line selection button
again to cancel a selected frame type. Use the up and down arrow buttons to scroll to
additional frame types. The EX7750 binds to each frame type as you select it.
When you have selected all the frame types used, choose Exit IPX/SPX Setup.
Exit IPX/SPX Setup
Select Frame Types
Clear Frame Types
IPX/SPX Setup
Exit IPX/SPX Setup
Ethernet 802.2 *
Ethernet 802.3
Ethernet II
IPX/SPX Setup