Xerox Phaser 7300B, Service Manual

Page: 140 / 277

4-124 Phaser 7300 Color Printer Service Manual
Note: Print a Configuration Page to provide a reference of the
current network settings prior to using any of the following
resets.
Resetting Network Setup Values To Default
Resetting the network setup values resets the TCP/IP address, TCP/IP address menu
settings (gateway, broadcast, etc.), CentreWare IS, EtherTalk, Netware, set IPX frame
type, IPP and Ethernet speed to their default values.
1. From the Main Menu, highlight
Connection Setup Menu
and press OK .
2. Highlight
Reset Connection Setup
and press OK .
3.
Reset Connection Setup NOW
is displayed, press OK .
Resetting All Printer Default Settings (PostScript NVRAM)
Resetting the NVRAM restores all printer values stored in the IP controller NVRAM
including network, printer setup, job defaults, color, margin, and calibrations to their
factory default values. The print counts and the Adobe firmware serial number are not
affected by this reset
1. From the Main Menu, highlight
Support
and press OK .
2. Highlight
Service Tools Menu
and press OK .
3.
Reset NVRAM
is displayed, press OK .
4. Highlight
Reset NVRAM and Reset Printer NOW
and press OK to reset all
the settings to their factory default values.
Service Diagnostics PostScript NVRAM Resets
Resetting NVRAM restores all printer values stored on the Image Processor Board
NVRAM including printer setup, job defaults, color, margin, and calibrations to their
factory default values. The consumable counts, network settings, and the Adobe
firmware serial number are not affected by this reset.
1. Enter Service Diagnostics.
2. Highlight
NVRAM Access
and press OK .
3. Highlight
PostScript NVRAM Reset
and press OK .
4.
Resetting NVRAM! Are you sure?
is displayed, highlight
Yes
and press OK .
5. The printer will exit Service Diagnostics, reboot, and reset the NVRAM.