System Administrator Functions
Configuring Power Saver Using the Embedded Web Server
You can set the time that the printer spends idle in ready mode before it automatically transitions to a
lower power level.
To configure Power Saver Timeouts:
1.
At your computer, open a Web browser. In the address field, type the IP address of the printer, then
press
Enter
or
Return
.
2.
In the Embedded Web Server, click
System
>
Power Saver
.
Note:
If this feature does not appear, log in as a system administrator. For details, refer to
Logging
In as the Administrator
on page 186.
3.
To set the time delay before the printer enters Low-Power mode, for
Low Power Timeout
, click
current value, then type the desired timeout in minutes.
4.
To set the time delay before the printer enters Sleep mode, for
Sleep Timeout
, click current value,
then type the desired timeout in minutes.
Note:
The sum of the two timeouts is within 60 minutes.
5.
To set Auto Power Off, click
Auto Power Off
:
−
To power off the device after all timeouts complete, select
On
, click current value, then type the
desired timeout in hours.
−
To power off the device only if specific conditions are met:
•
Select
Only When Conditions Are Met
.
•
Click current value, then type the desired timeout in hours.
Specific conditions are when Fax, USB Drive, Wired and Non-Wired Network features have not
been activated.
6.
To finalize your selections, click
OK
.
160
Xerox
®
Phaser
®
6510 Color Printer
User Guide
Summary of Contents for Phaser 6510
