![background image](http://html1.mh-extra.com/html/xerox/phaser-6360/phaser-6360_user-manual_4102675022.webp)
Configuring the Network Address
Phaser® 6360 Color Laser Printer
2-6
Automatically Setting the Printer’s IP Address
If the printer is connected to a small established TCP/IP network without a DHCP server, use
the installer on the
Software and Documentation CD-ROM
to detect or assign an IP address to
your printer. For further instructions, insert the
Software and Documentation CD-ROM
into
your computer’s CD-ROM drive. After the Xerox Installer launches, follow the prompts for
installation.
Note:
For the automatic installer to function, the printer must be connected to an established
TCP/IP network.
Dynamic Methods of Setting the Printer’s IP Address
There are two protocols available for dynamically setting the printer’s IP address:
■
DHCP (enabled by default on all Phaser printers)
■
AutoIP
You can turn on/off both protocols using the control panel, or use CentreWare IS to turn on/off
DHCP.
Note:
You can view the printer’s IP address at any time. On the control panel, select
Information
, press the
OK
button, select
Printer Identification
, and then press the
OK
button.
Using the Control Panel
To turn on/off either the DHCP or AutoIP protocol:
1.
On the control panel, select
Printer Setup
, and then press the
OK
button.
2.
Select
Connection Setup
, and then press the
OK
button.
3.
Select
Network Setup
, and then press the
OK
button.
4.
Select
TCP/IP Setup
, and then press the
OK
button.
5.
Select
DHCP/BOOTP
or
AutoIP
.
6.
Press the
OK
button to turn the selection
On
or
Off
.
Using CentreWare IS
To turn on/off the DHCP protocol:
1.
Launch your web browser.
2.
Enter the printer’s IP address in the browser’s
Address
field (http://xxx.xxx.xxx.xxx).
3.
Select
Properties
.
4.
Select the
Protocols
folder on the left navigation panel.
5.
Select
TCP/IP
.
6.
In the BOOTP/DHCP Settings section, set the
BOOTP/DHCP
option to
On
or
Off
.
7.
Click the
Save Changes
button.