Xerox Phaser 6280, Service Manual

Page: 373 / 672

Phaser 6280 Color Laser Printer Service Manual 4-85
General Troubleshooting
UNIX / Linux
This section includes:
■
Quick Install Steps
■
Additional Resources
Your printer supports connection to a variety of UNIX platforms through the
Parallel and Network interface. The workstations currently supported by
CentreWare for UNIX/Linux to a network-connected printer are:
■
Sun Solaris
■
IBM AIX
■
Hewlett-Packard HP-UX
■
Linux (i386) tested on SUSE 10.0, RedHat 9, Fedora Core1
The following procedures enable you to connect your printer using any of the
supported versions of UNIX or Linux listed above.
Quick Install Steps
Perform the following procedures to set up the printer and install the
appropriate drivers.
From the Printer
To set up the printer:
1. Verify that both TCP/IP protocol and the proper connector are enabled.
2. On the Control Panel, select one of these IP address options:
■
Allow the printer to set up a DHCP address
■
Enter the IP address manually
3. Print the Configuration page and keep it for reference.
From Your Computer
To install the CentreWare for Unix driver:
1. Go to www.xerox.com/office/drivers.
2. Select your printer, the platform your are running (UNIX), and file type
(Drivers).
3. Click Go to Downloads.
4. From the list of provided files, download the PrinterPackageXPXX and
the appropriate CentreWare printer driver for your platform <OS>XPXX
4.xx.x.tar.
a. As root untar the Driver and Printer package, this will create two
subdirectories. Cd to <O/S>InstallPackage and type ./setup to install
the driver.
b. CD to the PrinterPackagexpxx and type ./setup to install the printer
specific data files.