Xerox Phaser 6280, Service Manual, Page: 262 / 672

3-126 Phaser 6280 Color Laser Printer Service Manual
Error Messages and Codes
Optional Feeder Motor Error
The Optional Feeder Motor has failed.
Applicable Chain Link
■
Chain Link 042-325-04 : IOT Motor Failure
Initial Actions
■
Cycle printer power.
■
If the problem persists, follow the procedure below.
Troubleshooting Reference Table
Applicable Parts Wiring and Plug/Jack Map References
■
MCU Board, PL9.1.20
■
Feed Roll, PL12.1.9
■
Retard Roll, PL12.3.10
■
Right Side Harness, PL10.1.15
■
Optional 550-Sheet Feeder, PL12.1.1
■
Feeder Unit Harness, PL12.2.3
■
Tray 3 Feeder Board, PL12.2.6
■
C2 Motor Harness, PL12.2.9
■
Tray 3 Feeder Drive, PL12.2.10
■
Tray 3 Feeder Assembly, PL12.3.1
■
“Map 2 - Laser Unit, Feeder Assembly”
on page 10-10
■
“Map 4 - LVPS and MCU Boards” on
page 10-12
■
“Map 6 - Optional 550-Sheet Feeder” on
page 10-14
■
“Optional 550-Sheet Feeder Wiring
Diagram” on page 10-39
Troubleshooting Procedure Table
Step Actions and Questions Yes No
1 1. Check the detailed error code (press
the Up and Down buttons
simultaneously).
2. Does code “04” display on the
Control Panel?
Go to step 2.
■
Refer to
“Main Motor
Error” on
page 3-120
■
Refer to “Sub
Motor Error” on
page 3-122
■
Refer to “Tray
2 (PH) Motor
Error” on
page 3-124
2 1. Check the paper tray for correct
installation.
2. Is the tray correctly installed?
Go to step 4. Reseat the
paper tray.
Go to step 3.
3 Does the error still occur? Go to step 4. Complete.
4 1. Check the Feed Rollers and Retard
Rollers for rotation.
2. Do the Rollers rotate smoothly?
Go to step 5. Replace the
defective
Roller(s).