Xerox Phaser 6280, Service Manual

Page: 181 / 672

Phaser 6280 Color Laser Printer Service Manual 3-45
Error Messages and Codes
Jam at Tray 2 (Feed Jam)
Paper fed from Tray 2 did not reach the Registration Sensor on time.
Applicable Chain Link
■
Chain Link 077-903 : Jam at Tray 2
Initial Actions
■
Ensure that Tray 1 (MPT) is attached to the printer.
■
Try picking paper from a different tray.
■
Check the paper path for obstructions or debris.
■
Cycle printer power.
■
If the problem persists, follow the procedure below.
Troubleshooting Reference Table
Applicable Parts Wiring and Plug/Jack Map Reference
■
Tray 1 (MPT) Retard Roller Assy.,
PL2.1.3
■
Roll Assy Feed (Feed Roll), PL3.1.10
■
Feeder Assy., PL3.2.1
■
Regi Sensor, PL3.2.30
■
Regi Sensor Harness, PL3.2.37
■
Feed Roll, PL3.2.53
■
MCU Board, PL9.1.20
■
Right Side Harness, PL10.1.15
■
“Map 2 - Laser Unit, Feeder Assembly”
on page 10-10
■
“Map 4 - LVPS and MCU Boards” on
page 10-12
■
“Tray 1 (MPT) and Registration” on
page 10-23
■
“Feeder” on page 10-27
Troubleshooting Procedure Table
Step Actions and Questions Yes No
1 1. Check for paper jam.
2. Remove the jammed paper.
3. Does the error still occur?
Go to step 2. Complete.
2 1. Perform the Registration Sensor
test (page 4-30): Service Mode >
Engine Diag > Sensor Test > Regi
Sensor .
2. Does the number on the Control
Panel increase by 1 when the
Actuator of the Registration Sensor
is activated?
Go to step 8. Go to step 3.