Xerox Phaser 6180, Service Manual, Page: 285 / 616

Phaser 6180 Color Laser Printer Service Manual 4-51
General Troubleshooting
Regi Clutch
Caution
When performing this procedure, remove and cover the Print Cartridges
to avoid exposure to light.
1. Enter the Service Diagnostic menu (page 4-5).
2. Open the Front Cover.
3. Remove the Transfer Unit (page 8-7).
4. Remove the Print Cartridges (page 8-9).
5. Use a paper clip to secure the Interlock Switch.
6. Perform the Tray 2 Motor (FULL2) test: Engine Diag > Motor Test > Tray
2 Motor (FULL2) .
7. While the PH Motor is running, press the Up Arrow button to find Regi
Clutch . Press the OK button to run the Regi Clutch test.
Note
The Registration Rollers rotate when the Tray 2 Motor (FULL2) and the
Registration Clutch tests are executed.
8. Verify that the Tray 2 Motor is running and the Registration Rollers are
rotating.
9. Press the Cancel button to stop the Regi Clutch test.
10. Press the Down Arrow button to find Tray 2 Motor (FULL2) .
11. Press the Cancel button to stop the Tray 2 Motor test.
12. Remove the paper clip from the Interlock Switch.
Registration Rollers
s6180-377