Xerox PHASER 6130, Service Manual

Page: 169 / 454

Phaser 6130 Color Laser Printer Service Manual 3-67
Error Messages and Codes
Motor Error
The Main Motor has failed.
Applicable Chain Link
■
042-325 : Motor Error
Initial Actions
■
Cycle printer power.
■
If the problem persists, follow the procedure below.
6 Disconnect J503 from the LVPS.
defeat the front cover interlock and
measure the voltage across P503-1pin
<=> ground on the LVPS.
Does the voltage read about +24 VDC? Replace the Fan
(page 8-56). Replace the
LVPS
(page 8-55),
then go to step
7.
7 Does the error still occur when the
power is turned OFF and ON? Replace the
MCU Board
(page 8-59). Complete
Troubleshooting Reference Table
Applicable Parts Wiring and Plug/Jack Map References
■
MCU Board, PL8.2.13
■
Main Drive Assembly, PL8.1.2
■
“Map 1 - Transfer Unit, Control Panel,
Imaging Unit, Dispenser, Fuser” on
page 10-8
■
“Map 4 - Toner Dispenser Motors, HVPS,
MCU” on page 10-11
Troubleshooting Procedure Table
Step Actions and Questions Yes No
1 Check the Imaging Unit for correct
installation.
Is the Imaging Unit seated correctly? Go to step 3. Reseat the
Imaging Unit
and cycle the
power. Go to
step 2.
2 Does the error still occur? Go to step 3. Complete.
Troubleshooting Procedure Table (continued)
Step Actions and Questions Yes No