Xerox Phaser 6115 MFP, Service Manual

Page: 204 / 532

6-8 Phaser 6115MFP Multifunction Product Service Manual
Adjustments and Print Function Settings
Coding Scheme
Function:
Select compression method in TX/ RX mode.
Settings:
■
MMR: A compression method.
■
MR: A compression method.
■
MH: The simplest compression method.
■
JBIG (default): The most complex compression method that generates
the smallest code than any of following ones.
TNR Empty Rep (Toner Empty Report)
Function:
Select to generate a report to a specific destination when toner empty status
occurs in the engine.
Settings:
■
ON: Generate a report to report destination.
■
OFF (default): Not to generate report.
1. If “ON” is selected, select generate report and send to remote side when
toner runs out.
2. Enter the telephone number for which the report is to be produced.
Note
Fax number specifications: An up-to-20-digit number that may consist of
[0-9], [*], [#], [pause], and [space]. (0-9, #, *, pause, _)
The report will generate after 20 minutes, 24 hours, 48 hours, or 72 hours
after the event has occurred or until the condition is gone.
Protocol Report
Function:
Print communication report.
Choose one from among the following.
Settings:
1. OFF (default): Disable T.30 communication report.
2. ON: Print T.30 communication report.
3. ON ERROR: Print T.30 communication report when an error occurs.