Xerox PHASER 5400, Advanced Features And Troubleshooting Manual

Page: 14 / 127

Place the printer in an area where there is adequate space for ventilation, operation and servicing. The
recommended minimal spacing is 76 cm (29.9 in.) in front of the printer, 50 cm (19.7 in.) above the printer,
30 cm (11.8 in.) behind the printer, 20 cm (7.9 in.) on the side of the printer with the fan exhaust, and 10 cm
(4.0 in.) on the other side. Do not block or cover the slots and openings on the printer. Without adequate
ventilation, the printer may overheat.
For optimum performance, use the printer at elevations below 2,500 meters (8,200 ft.). Use at elevations
above 2,500 meters (8,200 ft.) exceeds operability limits.
Do not place the printer near a heat source.
Do not place the printer in direct sunlight.
Do not place the printer in line with the cold air flow from an air conditioning system.
Place the printer on a level, solid surface with adequate strength for the weight of the machine. The base
printer weight without any packaging materials is 27 kg (60 lbs.).
The printer is heavy, and must be lifted by two people. The illustration below shows the proper technique
for lifting the printer.
Exercise care in moving or relocating the printer, it is back-heavy and could tip backward. Follow the
recommended procedure when moving the printer from one location to another. Refer to the
Phaser 5400
Laser Printer Installation Setup poster.
Do not place any liquids on the printer.
Warning
Be careful when working in areas inside the printer identified with a warning symbol. These areas
may be very hot and could cause personal injury.
Wait 10-15 seconds between switching the printer off and on.
Keep hands, hair, neckties, etc., away from the exit and feed rollers.
While printing, follow these precautions:
Do not remove the media source tray that you have selected in the driver or front panel.
Do not open the covers.
Do not switch off the printer power.
Do not move the printer.
27 kg
60 lbs
3925-01