![background image](http://html.mh-extra.com/html/xerox/nuvera/nuvera_user-manual_885444061.webp)
Note
See your System Administrator to change any settings on the Stacking window.
When to unload Stackers
Various stackers are available for use with the Xerox Nuvera. Depending upon the situation, each of
these devices may require that paper be unloaded from the stacking tray. The table below shows each
of these unload situations for the BFM, DS3500/XPS, and the Xerox Production Stacker (XPS).
XPS
DS3500/XPS
BFM
Unload situation
Operator presses the Un-
load button on the finisher
• First or single press
starts the unload pro-
cess (eject), second
press pauses the
eject/raise/lower, third
press resumes
eject/raise/lower lower-
ing.
•
•
First or single press
starts tray lowering,
second pres stops
lowering, third press re-
sumes output tray
lowering, etc.Front door
must be opened/closed
to raise tray & allow
system to go ready
Single press or multiple
presses lowers tray to
unload position. Tray
lowers only enough to
enable BFM output tray
to slide out
or selects Unload on the
UI.
• After the unload is
complete the system
goes ready (continue
printing)
(continue print-
ing)Sheets are not re-
quired to be removed to
allow system to go
ready (continue print-
ing) after door is
opened/closed.(Note:
Paper present sensor is
about 1/4" in from the
Lead Edge.)
Operator opens the front
door while the Xerox
Nuvera is idle and paper is
present in the stacker.
• Opening is allowed.
• Opening is allowed.
• Can not open door
without pressing unload
button (door is inter-
locked)
• Sheets are not required
to be removed to allow
system to go ready
(continue printing) after
door is opened/closed
• Sheets are not required
to be removed to allow
system to go ready
(continue printing) after
door is opened/closed
Job is interrupted due to:
• Not applicable.
• Must open/close and
remove all sheets for
system to go ready
• Auto unload is sent.
• Restart
•
•
Must open/close and
remove all sheets for
system to go ready
(continue to print)
Auto unload is sent.
Must unload (eject) for
system to go ready
(continue to print).
• Sleep mode
(continue to print)
• Printer off/on
• Power off/on
7-3
Xerox
®
Nuvera
®
User Guide and Training Aid (UGTA)
Managing System Resources
Summary of Contents for Nuvera
