Xerox LF8040.8045, User Manual

Page: 70 / 92

70 ¦ Service · Restart the Recharging Process
EN
12. Pull the Plug’n’Print card out of the device.
Restart the Recharging Process
1. Press
OK
,
62
and
OK
.
2. Using
[
select
NEW BLACK
.
3. Confirm with
OK
.
4. Using
[
select
YES
. After a short time, the device will ask you to insert the Plug’n’Print card.
Query when Toner Level is Low
Displaying the Toner Level
Updating the Toner Level Memory
1. Press
OK
,
62
and
OK
.
2. Using
[
select
CART CAPACITY
.
3. Confirm with
OK
. The toner level of the toner cartridge is indicated by a percentile value
between 100 percent (full) and 0 percent (empty).
Notice
Cancel the Recharging Process
You can interrupt the recharging process at any time, by pressing
j
. However,
the toner level memory must be updated for each new toner cartridge.
Notice
Query when Toner Level is Low
If the toner level of the cartridge is low, then every time you open and close the cov-
er, the following question will appears on the display:
BLACK=NEW?
. If you have
not installed a new cartridge, press
j
. If you have installed a new cartridge, press
OK
and follow the description set forth above.
Notice
Updating the Toner Level Memory
Whenever you insert a new toner cartridge, you must update the toner level memory
of your device with the Plug’n’Print card that is included with the new cartridge.
Your device registers the extent of toner usage for every print-out and calculates the
toner level of the cartridge based on this. The indicated toner level is only meaning-
ful if you update each new toner cartridge with the Plug’n’Print card that is provided
with the cartridge.