Xerox Fiery EXP4110, Configuration And Setup

Page: 39 / 108

S
ETTING UP THE
F
IERY
EXP4110
FROM THE
C
ONTROL
P
ANEL
39
IPX/SPX Setup options
To specify the frame types the Fiery EXP4110 uses for IPX/SPX protocols, choose IPX/SPX
Setup from the Protocol Setup menu. You must choose at least one frame type to enable IPX/
SPX protocols. The Fiery EXP4110 supports the following frame types for IPX/SPX:
Ethernet 802.2, Ethernet 802.3, Ethernet II, and Ethernet SNAP
For protocols other than IPX/SPX, the frame type is automatically enabled and does not
require setup, as follows:
Select Frame Types
Enable IPX Auto Frame Type
Yes/No [No]
Specify whether the Fiery EXP4110 should try to bind to all available frame types
automatically. The Fiery EXP4110 does so whether or not all frame types are appropriate.
To determine whether any frame types were successfully bound, save your changes, exit Setup,
restart the Fiery EXP4110, and print a Configuration page. The Configuration page lists only
one of the frame types that were successfully bound.
If you answer No to this option, you can select frame types manually. You must choose at least
one frame type to enable IPX/SPX protocols.
Select each frame type used on your IPX/SPX network. An asterisk (*) appears beside each
selected frame type. Press the line selection button again to cancel a selected frame type. Use
the up and down arrow buttons to scroll to additional frame types. The Fiery EXP4110 binds
to each frame type as you select it.
When you have selected all the frame types used, choose Exit IPX/SPX Setup.
Clear Frame Types
You can clear all frame types at once by choosing Exit IPX/SPX Setup, choosing IPX/SPX
Setup, and then choosing Clear Frame Types.
Service Setup options
PServer is a program in the Fiery EXP4110 software that services the Novell print queues
assigned to the Novell print servers set up for printing to the Fiery EXP4110. When you
choose PServer Setup and enable PServer, you can set up NDS (Novell Directory Services),
Bindery Services, or both. NDS is used with NetWare; Bindery Services are used with
NetWare in bindery emulation mode.
With this protocol And these printing services This frame type is
automatically enabled
AppleTalk PAP (Printer Access Protocol) Ethernet SNAP
TCP/IP with Ethernet LPD (Line Printer Daemon) Ethernet II