Xerox DP N24, System Administrator Manual

Page: 235 / 336

Installing the Maintenance Kit
Appendix B: Maintaining the Printer
❖
B-11
Installing the
Maintenance Kit
The Maintenance Kit is comprised of three items:
• Fuser Cartridge
• Bias Transfer Roll (BTR)
• 15 feedrolls (three for each paper input tray)
The Fuser Cartridge, feedrolls and BTR have expected useful lives
of 300,000 impressions. Although printing can continue, to ensure
optimum print quality you should order and replace the
Maintenance Kit as soon as possible.
This section describes how to replace the DP N40 Maintenance Kit.
Ideally, all three items of the Maintenance Kit should be replaced at the
same time to maintain a consistent maintenance cycle. It is your
responsibility to install the Maintenance Kit to keep the machine in
optimal condition. It is also your responsibility to determine when this
kit installation is required. A Olivetti Service Representative can be
called to install this kit for a fee.
Loose toner may get on your hands during this procedure. You can use
the supplied cleaning pad to clean your hands after completing the
installation.
The Fuser area becomes extremely hot during use of the printer. Be
sure to power OFF the printer and leave it to cool off for at least 15
minutes before replacing the Fuser Cartridge.