Xerox DP N24, System Administrator Manual

Page: 16 / 336

Special Features
1-8
❖
DP N24, N32 and N40 System Administrator Guide
Special Features
Several features have been designed into the DP N40 to enhance
your printing environment. Using the printer's Control Panel menu
system, you can tailor printer settings to match your printing
requirements.
See Chapter 3: Using the Control Panel for more information about
the Control Panel and its menu system.
Connectivity The N40 includes the following physical connectivity interfaces on
board:
• IEEE 1284 Bi-directional parallel
• RS232C Serial Interface with a DB9 Connector
• Ethernet (10 Mbit)
Two additional interfaces are available as options.
• Ethernet (100 Mbit)
• Token Ring
Installing either optional network interface disables the on board 10
Mbit Ethernet interface. Removing either optional interface enables
the on board 10 Mbit Ethernet functionality again.
Power Saver
After 60 minutes of inactivity, the printer automatically turns off
internal components to reduce the amount of electricity used. The
printer automatically turns those parts back on when it receives a
print job.
Using the printer's Control Panel menu system, you can send the
printer into Power Saver mode after your choice of Off, 15, 30, 60,
90, 120 or 180 minutes of inactivity.
See the section “System Menu” (page 3-33) in Chapter 3: Using
the Control Panel.
High Resolution
Printing
The DP N40 is set to print at 600 x 600 dpi (dots per inch). You can
also print draft-quality jobs by using the System Menu to set Draft
Mode to On. The printer automatically reduces the amount of toner
by two-thirds (and prints a draft-quality output). Draft Mode can be
selected on a per job basis from the Olivetti printer drivers.
See Chapter 3: Using the Control Panel for instructions on
changing Control Panel settings.