6/98
Xerox DocuPrint N17 Service Manual
7-91
Repair Analysis Procedures (RAPs)
7.5.5 Black Prints
Initial Actions
•
Ensure that print density (see
Section 5.2.3 Diagnostic Mode 3 for more information) is set to
default (3).
•
Generate the System Controller Test Print,
Section 5.1.4.13 Print Menu, and Print Engine
Controller Test Print,
•
If both prints are completely black, replace the EP Cartridge.
•
If any image is visible on the prints, go to
Procedure
1 Only the System Controller Test Print is black.
Y: Check the seating of the System Controller. If OK replace the System Controller.
N: Go to step 2.
2 Cover the Laser Assembly window (laser beam outlet) using a piece of paper, and generate a
test print. The entire print is still black.
Go to RAP 7.4.24 HVPS Failure.
N: Go to step 3.
3 Cover half of the Laser Assembly window (laser beam outlet) using a piece of paper, and
generate a test print. The print is black only in the area not covered with the paper.
Go to RAP 7.3.2 “Laser Fail - Power Off/On” Message (U2).
N: Go to step 4.
4 The HVPS has faulty output. Refer to
REP 5.2.1.21 HVPS (Charge Roll DC) Operation and
perform diagnostic.
Y: Go to
N: Install a new EP Cartridge.
Definition
The entire print is black.
Sample Image
www.printcopy.info
www.printcopy.info
