6/98
Repair Analysis Procedures (RAPs)
7-66
Xerox DocuPrint N17 Service Manual
7.4.22 Exit Assembly Failure
1 There is +24VDC between P/J12-1 and P/J12-4 on the LVPS.
Y: Go to step 2.
N: Replace the LVPS Assembly.
2 There is continuity between J12 on the LVPS and J25 on the Print Engine Controller.
Y: Go to step 3.
N: Replace the LVPS Harness Assembly.
3 There is +24VDC between the following points.
• P/J24-1 and P/J25-4 on the Print Engine Controller
• P/J24-2 and P/J25-4 on the Print Engine Controller
Y: Go to step 4.
N: Replace the Print Engine Controller.
4 There is continuity between the following points (approximately 2.3 ohms) on the Print Engine
Controller.
• P/J24-1 and P/J24-3
• P/J24-1 and P/J24-5
• P/J24-2 and P/J24-4
• P/J24-2 and P/J24-6
Y: Go to step 5.
N: Replace the Exit Motor Assembly.
5 Manually crank the following transmission gears of the Exit Assembly.
• Exit Roll Assembly
• Mid Roll Assembly
Y: Go to step 6.
N: Replace the Exit Assembly.
6 Manually crank the Exit Motor Assembly.
Y: Go to step 7
N: Replace the Exit Motor Assembly.
7 Install a new Print Engine Controller. The problem is still present.
Y: Replace the Exit Assembly.
N: The correction is completed.
www.printcopy.info
www.printcopy.info
