Xerox document centre285 series, User Manual

Page: 133 / 209

5.3 Common Menu Items
121
Mode
M
e
nu and Common Menu
5
Internet Service The following item is to be set when using Internet Service.
The candidate values are:
•
Enable (default)
•
Disable
If it is set to Enable, you can, through a web browser, make use of the
CentreWare Internet Services to display the printer/job status and change
printer settings.
●
To activate the Internet Service, you will need to set the IP address on both the
computer and printer.
●
You can make use of CentreWare Internet Services to set detailed settings. For
more details, refer to "5.5.7 Using CentreWare Internet Services"
TCP/IP Settings Get IP Address
Sets the way of obtaining the essential information for using TCP/IP (IP
address, subnet mask, gateway address). The candidate values are:
• DHCP (default)
•
RARP
•
BOOTP
• Manually
Check with your system administrator for the address if you choose Manually.
If you change the setting from DHCP or BOOTP to Manually, you will need to set the IP
address manually on the screen displayed for setting IP address.
IP Address, Subnet Mask, Gateway Address
These items will be available whether you choose Manually or automatically
(i.e. by DHCP, BOOTP or RARP) for Get IP Address. If you have chosen
Manually, enter the value for these items in the XXX.XXX.XXX.XXX format
where XXX is between 000-255.
●
If a wrong IP Address is set, the whole network might be badly affected.
●
If a wrong Subnet Mask is entered (e.g. setting the bit to "0"), the value will resume
the previous setting even if you have pressed after the entering the value. You
cannot navigate to other items until the correct value is set.
●
Enter the Gateway Address only when it is clear that there is a need to do so. You do
not need to set it for environment that allows it to be set automatically.
When you are pressing or to change the candidate value, press and hold
on to the button to run the displays continuously. When both of these buttons are
pressed together, the value will be reset to the factory setting.
Menu item Explanation