Xerox document centre285 series, User Manual

Page: 130 / 209

5.3 Common Menu Items
118
Mode
M
e
nu and Common Menu
5
USB
(con’t...) Adobe Protocol
Sets the PostScript protocol. Available only when PostScript Kit is installed.
The candidate values are:
•
Normal (default)
For communication protocol in ASCII format.
• Binary
For communication protocol in binary format. Depending on the data, the
print processing in this protocol may be faster than Normal.
• TBCP (Tagged Binary Communications Protocol)
For communication protocol in a mixture of ASCII or binary format which is
switched by a specific control code.
●
Select the protocol to match the format of the data output by the printer driver.
●
For normal use, select Normal.
Auto Eject Time
Sets the time to automatically print and output any remaining data in the
printer when it is in a continuous state of not receiving data.
The range of setting is between 5-1275 seconds with 5 seconds per unit.
Default is 30 seconds. When the next data is not received within the time set
here after the last data has been received, it will be deemed as end of job.
When you are pressing or to change the candidate value, press and hold
on to the button to run the displays continuously. When both of these buttons are
pressed together, the value will be reset to the factory setting.
Port9100 The following items are to be set when using Port9100:
Port Status
Sets the port status of the Port9100 port when the power is switched on. The
candidate values are:
• Enable
•
Disable (default)
If the memory is not enough when the Port Status is set to Enable, it may be set to
Disable automatically. When this happens, either set the Port Status of other ports not
in use to Disable or change the memory allocation.
Print Mode
Sets the printer language. The candidate values are:
•
Auto (default)
The language to be used will be determined automatically
•
PCL
•
PS (available only when PostScript Kit is installed)
When the value is set to Auto, and if the printer language used cannot be found by the
automatic printer language detection feature or it is not the selected printer language,
the data may be erased.
Menu item Explanation