1
1-20
Installing User Software on a Windows Computer
Completing the Windows NT 4.0 printer connection
To print from Windows NT 4.0, you must:
• Set up network servers, if any.
• Set up the Fiery to accept print jobs from your computer.
• Configure a port on each Windows NT 4.0 computer for the network type.
Completing the Windows NT 4.0 TCP/IP and LPR connection
After installing the PostScript printer driver and printer driver files, complete the setup
for the TCP/IP and LPR connection by performing the following steps:
• Prepare the Fiery to accept print jobs using TCP/IP and LPR protocols.
• Enable LPD from the Fiery Control Panel. For details, see the
• Configure the computer for the TCP/IP connection.
Before you continue, contact the system administrator for the IP address assigned to
the Fiery, as well as the subnet mask and the gateway address, if they are used.
The TCP/IP protocol should already be installed on your Windows NT computer.
To do this
See
Configure the TCP/IP (LPR port)
connection
“Completing the Windows NT 4.0 TCP/IP
and LPR connection”
Configure the IPX (Novell) connection
“Completing the Windows NT 4.0 IPX
(Novell) connection”
Configure the SMB connection