2
2-21
Using AutoCal and ColorCal
Using AutoCal and ColorCal
AutoCal and ColorCal let you calibrate the Fiery without the use of an additional
spectrophotometer or densitometer. Instead, these methods use the copier’s built-in
scanner to measure toner density values.
You can perform AutoCal and ColorCal calibration from either ColorWise Pro Tools
or the Fiery Control Panel. For troubleshooting during the AutoCal procedure, see the
N
OTE
:
To calibrate using AutoCal or ColorCal, you will need the Kodak Gray Scale
strip included in the customer media pack that came with your Fiery.
Calibrating with ColorWise Pro Tools and AutoCal or ColorCal
When you run ColorCal from ColorWise Pro Tools, you have the option to calibrate
the copier’s scanner before calibrating the Fiery itself. This option is not available for
AutoCal.
T
O
CALIBRATE
WITH
C
OLOR
W
ISE
P
RO
T
OOLS
AND
A
UTO
C
AL
OR
C
OLOR
C
AL
1.
Start Calibrator.
For instructions on starting Calibrator, see
2.
In the Select Measurement Method pane, choose AutoCal or ColorCal.
3.
In the Check Print Settings pane, choose the desired calibration set.
If more than one option appears, choose the appropriate calibration set for the type of
media you will use most often.
N
OTE
:
For this calibration to take effect, the calibration set must be associated with one
or more output profiles. The default calibration set is already associated with the
default output profile, so there is no need to make any new associations.
EX12
EX12
