A
A-8
Color Measurement Instruments
10.
Insert the end of the Color Reflection Reference strip with the arrow into the
calibration strip entrance on the DTP41, centering it below the alignment mark
(see the diagram on
Insert the strip about 3 inches, past the front idler rollers, until it rests against the rear
drive rollers.
11.
Click Read Reference in the Instrument Calibration dialog box.
The DTP41 pulls the calibration strip through automatically.
A message appears in the Status area when the calibration is finished.
12.
Click Done.
13.
Close the Utilities window.
This completes DTP41 calibration.
When the DTP41 requires calibration, your computer prompts you. When the
prompt message appears, click Calibrate Now and follow the instructions, starting
with
.
After calibrating the DTP41, calibrate the Fiery (see
).
Using the X-Rite DTP32 densitometer
ColorWise Pro Tools are designed to work with the X-Rite DTP32 reflection
densitometer, which feeds color measurements to the Fiery automatically.
N
OTE
:
Measurements from other densitometers can be input using a simple
ASCII file format (see
Setting up the DTP32
Before you calibrate the Fiery using the X-Rite DTP32, you need to connect,
configure, and calibrate the densitometer to prepare for measuring the printed patches
(see
on page A-11). For additional information about setting
up and using the DTP32, see the separate documentation included with the
densitometer.
