Xerox DocuCentre SC2020, User Manual

Page: 178 / 322

Tools
Xerox
®
DocuCentre
®
SC2020
User Guide
175
System Settings
Use [System Settings] to configure a variety of device features.
Note: Bold values are the factory default menu settings.
General
Purpose: To configure general settings for the device.
Power Saver
Purpose: To specify the time for transition to Power Saver mode.
Values:
When you specify 1 minutes for [Low Power Timer], the device enters Power Saver mode 1 minutes after it
finishes a job. This uses much less energy, but requires more warm-up time for the device. Specify 1
minutes if the device shares an electrical circuit with room lighting and you notice lights flickering.
Select a high value if the device is in constant use. In most circumstances, this keeps the device ready to
operate with minimum warm-up time. Select a value between 1 and 60 minutes for [Low Power Timer] if
you want a balance between energy consumption and a shorter warm-up period.
The device automatically returns to the standby mode from the Power Saver mode when it receives data
from the computer or remote fax device, while keeping the touch screen turned off to save power. Pressing
the <Power Saver> button on the control panel changes the status of the device to the standby mode and
lights up the touch screen.
Date & Time
Purpose: To specify the date and time formats.
Values:
Print On Error Prints the protocol monitor report only when an error occurs.
Print Disable Does not print the protocol monitor report.
Low Power Timer 1 min Specifies the time taken by the device to enter Low
Power mode after it finishes a job.
1–150 min
Sleep Timer 0 min Specifies the time taken by the device to enter Sleep
mode after it has entered Low Power mode.
0–60 min
Time Zone Sets the time zone.