Using the Telephone
489
A
p
pe
nd
ix
15
Using the Telephone
This section describes how to use an external telephone connected to the machine with
the fax feature.
Placing a Call
The following describes how to place a call using the external telephone.
To place a call, there are the following two methods.
z
Dialing with the receiver lifted (off-hook dialing)
z
Dialing with the receiver resting in the cradle (on-hook dialing)
Off-hook Dialing
The following describes how to place a call with the receiver off-hook.
1
Pick up the receiver of the external
telephone.
Note
•
While the machine is in the
Energy Saver mode, you
cannot place a call using the
external telephone. To place a
call, press the <Energy
Saver> button to switch out of
the Energy Saver mode.
2
Specify the call destination.
z
The call destination can be specified using the numeric keypad, address numbers,
or one-touch buttons. The address book cannot be used.
z
The call destination can be
specified also with the keyboard
displayed on the screen.
Selecting [More Characters] on
the screen displays symbols.
Note
•
To cut the line, select [Exit
(Line Cut)].
•
If your telephone line is set to touch-tone, [Tone (:)] does not appear.
•
If you want to send tones (or to use the touch-tone services) while using a pulse line, select
[Tone (:)].
•
Some touch-tone services may not be available even if you set your telephone to send
tones.
3
When the call is connected, start speaking.
4
When the call is finished, place the receiver back in the cradle.
Important •
Make sure that the receiver is placed properly in the cradle. Otherwise, the line will remain
"busy".
5
Select [Close].
