Connectivity & Network Setup
137
T
ools
5
UPnP Discovery - Port Number
Select [Standard (80)] or [Enter Number].
Enter a port number in the range from 1 to 65535 when selecting [Enter Number].
The default value is 80.
Important •
Do not use the numbers assigned to the other ports.
Internet Services
Port Status
Select [Enabled] to use CentreWare Internet Services.
For more information about CentreWare Internet Services, refer to "CentreWare Internet Services
Settings" (P.215).
Internet Services Port Number
Select [Standard (80)] or [Enter Number].
Enter a port number in the range from 1 to 65535 when selecting [Enter Number].
The default value is 80.
Important •
Do not use the numbers assigned to the other ports.
Note
•
[Port Number] cannot be configured if [Port Status] is set to [Disabled]. To configure [Port
Number], enable [Port Status], select [Save], and then reboot the machine.
SOAP
Port Status
Select [Enabled] when you are using an application program, such as the EasyOperator.
SOAP - Port Number
Select [Standard (80)] or [Enter Number].
Enter a port number in the range from 1 to 65535 when selecting [Enter Number].
The default value is 80.
Important •
Do not use the numbers assigned to the other ports.
WebDAV
Port Status
Select [Enabled] when you are using an application program for accessing the Mailbox in the
machine, such as the EasyOperator.
Note
•
You can not configure [WebDAV - Port Number] and [WebDAV - Operation Time-Out], if
WebDAV port is disabled.
Enable WebDAV port first and select [Close] and [Reboot Now] to reboot the machine, and
then configure [WebDAV - Port Number] and [WebDAV - Operation Time-Out].
WebDAV - Port Number
Select [Default Port (80)] or [Enter Number].
Enter a port number in the range from 1 to 65535 when selecting [Enter Number].
The default value is 80.
Important •
Do not use the numbers assigned to the other ports.
WebDAV - Operation Time Limit
You can enter a operation time-out period between 1 and 65535 seconds in 1 second
increments.
Protocol Settings
Set the parameters required for communications. In [Protocol Settings], you can set the
following items.
Ethernet Rated Speed
Set the communication speed for the Ethernet interface.