Loading Paper
LO A D I N G PA P E R I N T R AYS 1 – 4
For configurations with the 2–Tray Module, use the same method to load paper in both Trays 1 and 2 and Trays 3
and 4. For instructions on how to load paper in Trays 3 and 4 when they are part of the Tandem Tray Module, refer
to
Loading Paper in Trays 3 and 4 of the Tandem Tray Module
.
The system administrator can set Trays 1–4 to Fully Adjustable mode or Dedicated mode. Each time a tray is
opened and closed, the paper settings appear on the control panel.
• When trays are configured as Fully Adjustable, you can confirm or change the media settings. The paper guides
automatically detect the size of paper that is loaded.
• When trays are configured as Dedicated, the control panel displays the media settings for the tray. A warning
message appears on the control panel when the wrong media is loaded in the tray, or when the paper guides
are set incorrectly.
Note: Only the system administrator can change the media settings for a dedicated tray. For details on how
to configure tray settings, refer to
Configuring Paper Tray Settings
.
When the paper in the tray is in short supply, or when a tray is empty, a warning message appears on the control
panel.
To load paper in Trays 1–4:
1.
Pull out the tray until it stops.
2.
Remove any paper that is a different size or type.
3.
To move out the length or width paper guides, pinch the guide locks, then slide out the length or width paper
guides.
Xerox
®
AltaLink
®
C8130/C8135/C8145/C8155/C8170 Series Color Multifunction Printer User Guide
209
