Xerox B210, User Manual

Page: 52 / 199

Network Connectivity
Xerox
®
B210 Printer
User Guide
52
Enabling SNMP Using Xerox
®
CentreWare
®
Internet Services
1. In Xerox
®
CentreWare
®
Internet Services, click Properties

Connectivity

Protocols .
2. Click SNMP .
3. For Protocol , select Enable .
4. To configure the SNMP properties, for Edit SNMP Properties , click Edit .
5. For Community Names , enter the GET and SET community names.
6. For Default TRAP Community Name , type a name.
7. For Authentication Failure Generic Traps , to generate a trap for every SNMP request received by
the printer which contains an invalid community name, click
Enable
.
8. Click
Apply
.
Configuring SNMP Trap Destination Address Using Xerox
®
CentreWare
®
Internet Services
You can add, edit, or delete IP addresses for Network Management workstations that receive traps
from the device.
1. In Xerox
®
CentreWare
®
Internet Services, click Properties

Connectivity

Protocols .
2. Click SNMP .
3. In the Trap Destination Address section, click Add IP Address .
4. For IP Trap Destination Address , type the IP address of the host running the SNMP manager that
receives traps.
5. Type the
UDP Port Number
.
6. To add the traps, perform the following steps.
•
For
TRAP Community Name
, type a name.
• For
Traps to be Received
, select the type of traps that the SNMP manager receives.
7. Click
Apply
.
SNMPv3
SNMPv3 is the current standard version of SNMP defined by the Internet Engineering Task Force
(IETF). It provides three important security features:
• Message integrity to ensure that a packet has not been tampered with in transit
• Authentication to verify that the message is from a valid source
• Encryption of packets to prevent unauthorized access
Note: When configuring settings in Properties, you will be prompted to enter the Administrator
account user name and password. For information about logging in as an administrator, refer to
Accessing the Xerox® CentreWare® Internet Services Administrator Account .