Xerox ApeosPort-II 3000, User Manual

Page: 594 / 619

16 Appendix
592
Appe
nd
ix
16
On-hook Dialing
The following describes how to place a call with the receiver on-hook. When placing a
call on-hook, we recommend turning the line monitor volume to "Loud".
The volume of the line monitor can be changed in the System Administration mode. For information on
how to change the volume, refer to "Line Monitor Volume" (P.270). By factory default, the volume is
set to [Normal].
1
On the [All Services] screen, select
[Fax/Internet Fax].
2
Select [On-hook (Manual Send/
Receive)] on the [Advanced
Features] screen.
3
Specify the call destination.
z
The call destination can be specified using the numeric keypad, address numbers,
or one-touch buttons. The address book cannot be used.
z
The call destination can be
specified also with the keyboard
displayed on the screen.
Pressing [More Characters] on
the screen displays symbols.
Note • To cut the line, select [Exit
(Line Cut)].
• If your telephone line is set to touch-tone, [Tone (:)] does not appear.
• If you want to send tones (or to use the touch-tone services) while using a pulse line, select
[Tone (:)].
• Some touch-tone services may not be available even if you set your telephone to send
tones.
4
When the call is connected, lift the
receiver and start speaking.
5
After the call is finished, place the
receiver back in the cradle.
Important • Make sure that the receiver is placed properly in the cradle. Otherwise, the line will remain
"busy".