Xerox ApeosPort-II 3000, User Manual

Page: 45 / 619

Power Saver Mode
43
P
roduc
t O
v
er
vie
w
2
Power Saver Mode
The machine is installed with the Power Saver feature that will automatically cut off the
electricity to the machine if no copy or print data is received for a certain duration.
The Power Saver feature has two modes: [Low Power mode] and [Sleep mode].
The machine enters the Low Power mode if the machine is left unused for a certain
period of time.
The machine then enters the Sleep mode after a further period of inactivity.
„ Low Power Mode
In this mode, the power to the control panel and fuser unit is lowered to save power.
The touch screen goes out, and the <Power Saver> button on the control panel lights
up. To use the machine, press the <Power Saver> button. The <Power Saver> button
then goes out and the Power Saver mode is exited.
„ Sleep Mode
In this mode, the power is lowered more than in the Low Power mode.
The touch screen goes out, and the <Power Saver> button on the control panel lights
up. To use the machine, press the <Power Saver> button. The <Power Saver> button
then goes out and the Power Saver mode is exited.
Changing the Power Saver Mode Change Interval
The procedure for setting the Power Saver feature is as follows.
To activate the Power Saver feature, set both the times until the activation of Low
Power Mode and Sleep Mode.
1
Press the <Log In/Out> button.
2
Enter the user ID with the numeric
keypad, and select [Confirm].
Note • The default User ID is
"11111". When using the
Authentication feature, a
passcode is required. The
default passcode is "x-admin".
3
Select [System Settings].
1 2 3
4 5 6
7 8 9
0 #
C
<Log In/Out>
button