Xerox 5400N - Phaser B/W Laser Printer, Service Quick Reference Manual

Page: 270 / 503

Phaser 5400 Laser Printer Service Guide 241
Maintenance and Cleaning
Scheduled Maintenance
The Phaser 5400 Laser Printer is designed and tested to require little maintenance. A
User Maintenance Kit (P/N 109R00521 for 110 volt printers and 109R00522 for
220 volt printers) contains:
■
Replacement Fuser
■
Bias Transfer Roller
■
Cleaning Cloth
The printer will tell the user when to install the User Maintenance Kit
(200,000 prints). Normally, it is not necessary for a trained technician to install the
kit. Following installation, it is necessary to reset the maintenance counter.
Note: See NVRAM Adjustments in the Diagnostics, Test Prints,
Services Tests and NVRAM Adjustments section of this
manual for this procedure.
Recommended Tools
■
Standard service tools used in printer repair
■
Toner vacuum, such as the 3M Toner Vac
Caution: Do NOT use a standard vacuum to clean up a toner spill.
■
Suction bulb to use as an air puff blower
■
Toner rags (specially treated fibrous paper cleaning “rags” that attract and
pick up toner and dust particles
■
Cotton swabs (for those hard to get at places)
■
Cleaning cloth
■
Isopropyl alcohol
■
Simple Green or equivalent cleaner
Inspect While Servicing
The above represents all the scheduled maintenance for this printer; however, it is
important for all qualified service technicians to always inspect and clean
“on-the-fly” whenever repairing or otherwise servicing the printer.