Xerox 5400N - Phaser B/W Laser Printer, Service Quick Reference Manual

Page: 260 / 503

Phaser 5400 Laser Printer Service Guide 231
Registration
Purpose
To adjust the registration in the scan direction and the process direction.
To Set Default Tray
1. Enter Diagnostics Mode and press [1] or [5] to scroll to “Main Menu / Test Print”.
2. Ensure the paper guides are properly set to match the paper size.
3. Press [2] or [6] to scroll to “Input Tray”.
4. Press [3] or [7] to scroll to the tray that you wish to be the Default Tray.
5. Press [4] to set.
Check
1. Set the Default Tray per the above procedure.
2. Ensure paper is loaded correctly and the side paper guides are properly set.
3. Press [1] or [5] to scroll to “Main Menu / Test Print”.
4. Press [2] or [6] to scroll to “Print Pattern” and press [4].
5. After at least two prints complete, press the [0] key for one second to stop the
printing.
6. The measurement should be made on two consecutive test patterns from each tray.
■
Measure the distance from the top edge of the paper to the top edge of the
image (C) and measure the distance from the bottom edge of the paper to the
bottom edge of the image (D). These two measurements should be equal (see
Figure 35).
■
Measure the distance from the lead edge of the paper to the lead edge of the
image (A) and measure the distance from the trail edge of the paper to the
trail edge of the image (B). These two measurements should be equal (see
Figure 35).
7. If either measurement does not meet specification perform the adjustment below.
8. Repeat steps 1 through 6 for each paper tray.
Adjustment
1. Press [1] or [5] to scroll to “NVM Config.”
2. Enter the NVM Password in this sequence: [0], [7], [3] and [4] .
3. Press [2] or [6] to scroll to “Process Tray ‘X’” or “Scan Tray ‘X’” adjustment for
the desired tray.
■
Process Tray X shifts the image from the Leading Edge to Trailing Edge (A
to B).
■
Scan Tray X shifts the image from top to bottom (C to D).
4. Press [3] or [7] one time to display the current setting.
5. Press [3] or [7] again to scroll to a new setting / value.