Xerox 5400N - Phaser B/W Laser Printer, Service Quick Reference Manual

Page: 244 / 503

Phaser 5400 Laser Printer Service Guide 215
RAP 86 Unfused Image
The printed image is not fully fused to the paper. The
image rubs off easily.
Figure 34 Unfused Image
Table 117 Unfused Image Troubleshooting Procedure
Step Actions and Questions Yes No
1 INITIAL ACTIONS
■
Ensure that the paper is within specification.
2 PAPER REPLACEMENT
1. Replace paper with fresh, dry standard paper.
2. Run a Test Print.
Is the problem still present?
Go to
Step 3. Problem
solved.
3 CHECK FUSER SETTING
Refer to Non-Volatile Memory Setup Mode and check
the Fuser Setting.
Is the NV code set to factory default value?
Go to
Step 5. Go to
Step 4.
4 RESET TO FACTORY DEFAULT
1. Set NV code to the factory default value.
2. Run 25 Test Prints.
Is the problem still present?
Increase the
fuser
temperature
by one
increment
and run 25
test prints.
Recheck /
repeat as
necessary. Problem
solved.
5 Is the overall print density within specification? Go to
Step 6. Go to
RAP 70,
page 178 .