Xerox 5400N - Phaser B/W Laser Printer, Service Quick Reference Manual

Page: 118 / 503

Phaser 5400 Laser Printer Service Guide 89
RAP 24 Error Code E9-3: Tray 2 Failure
Power Off / On
Tray 3 Failure
Power Off / On
The HCF has failed or disconnected with Power-On.
Table 44 Error Code E9-3: HCF Fail (2000-Sheet Feeder) Troubleshooting
Procedure
Step Actions and Questions Yes No
1 HARNESS CONNECTIONS
1. Switch printer power OFF.
2. Remove the Lower Rear Cover.
3. Inspect the connection at both ends of the 2000-Sheet
Feeder harness Assembly (P/J601 on the Feeder
Board and P/J131 feeder Interface Harness).
Is the 2000-Sheet Feeder Interface Harness
properly connected to the 2000-Sheet Feeder
Board?
Go to
Step 2. Secure the
connections
of the
2000-Sheet
Feeder
Harness
Assembly
[J131, J601].
2
2000-SHEET FEEDER BOARD REPLACEMENT
Replace the 2000-Sheet Feeder Board [PL 12.2,
page 420 ].
Does the problem still occur?
Go to
Step 3. Problem
solved.
3 HARNESS CONTINUITY CHECK
1. Remove the 2000-Sheet Feeder Harness assembly.
2. Check for continuity between the pins as follows:
■
J601-1 and J131-7
■
J601-2 and J131-6
■
J601-3 and J131-5
■
J601-4 and J131-10
■
J601-5 and J131-13
■
J601-6 and J131-9
■
J601-7 and J131-8
Is there continuity between all pins measured?
Replace the
Print Engine
Controller
Board
[RRP 8.5,
page 310 ].
Repair or
replace the
2000-Sheet
Feeder
Harness
Assembly
[PL 12.2,
page 420 ].
4 SUSPECT COMPONENTS
The following printer components and areas are
associated with this specific problem. One or more of
these components or areas may have failed partially or
completely. If you cannot isolate this problem using the
steps in this Repair Analysis Procedure, replace each
component or troubleshoot each area listed below, one
at a time, until you isolate and solve the problem.
■
Print Engine Controller Board [RRP 8.5, page 310 ]
■
2000-Sheet Feeder Board [PL 12.2]
■
2000-Sheet Feeder Harness Assembly [PL 12.2]