Xerox 2101, Configuration Manual

Page: 74 / 192

4
4-18 Performing Setup from the Control Panel
Get Gateway Address Automatically
Yes/No [Yes]
Use this option to assign the gateway address automatically for printing with TCP/IP.
This option appears only if you selected DHCP or BOOTP as the protocol in the
previous option.
IP Address
[127.0.0.1]
This option appears only if you answered No to Enable Auto IP Configuration.
Enter the Fiery EX2101 IP address for Ethernet. This IP address, unlike an IP address
set automatically, remains the same if you restart the Fiery EX2101. You must change
the default to a valid address for your network. For information about setting up
printing with TCP/IP, see
Chapter 2 .
Subnet Mask
This option allows you to modify the subnet mask for printing with TCP/IP over
Ethernet. To set the subnet mask, enter one of the following values:
•
255.0.0.0
if the IP address starts with a number less than 128
• 255.255.0.0 if the IP address starts with a number from 128 through 191
•
255.255.255.0
if the IP address starts with a number greater than 191
N
OTE
:
Confirm the subnet mask setting with your network administrator before
proceeding. In some cases, the required setting may be different from that listed.
Gateway Address
[127.0.0.1]
This option appears only if you answered Get Gateway Address Automatically.
Use this option to set the gateway address for printing with TCP/IP. If your network
uses a gateway, you must change the default to a correct gateway address for
your
network.