XMR User Manual 1.1
25
Generating your Key
This process uses uCon Terminal Emulator, but any terminal emulator can be used.
Getting the COM Port
1.
Connect the XMR to your PC via the required cable.
2.
Take note of the COM port number in Control Panel → Device Manager
Connect Using Terminal Emulator (uCon)
1.
the uCon Serial Console software
2.
Install uCon and open the program
3.
Connect to the XMR using the following settings
(right), use the COM port from the previous section.
4.
Press Ok. Turn on echo by going to Config →
Miscellaneous (see below)
5.
Enter your encryption passphrase by entering
$aky
PASSPHRASE
The pass phrase must be exactly 32 characters long.
Note:
This step cannot be done through Iridium.
Enabling Encryption Use
1.
To enable encryption, send the command: $aenbl 1
2.
To disable encryption, send the command: $aenbl 0
Summary of Contents for XMR Series
Page 1: ...1 XMR User Manual Waterproof Iridium Data Transceiver Version 1 1 February 2021...
Page 36: ...XMR User Manual 1 1 34 Appendix D Mechanical Drawings...
Page 37: ...XMR User Manual 1 1 35...
Page 38: ...XMR User Manual 1 1 36 Appendix E Cable Drawings A 05 090 XMR Power Communications Cable...
