Xeos Apollo-X7, User Manual

Page: 24 / 41

Apollo-X User Manual Version 0.9 24
Default Timer Settings
Timer <T0> T1 T2 T3 T4 T5 T6 T7 Min-Max
GPS 1h 15m 10m n/a 2h 10m n/a 1h 30s-7d
SBD 1h 15m 10m 1d 1h 10m n/a 1h 30s-7d
WTR 1m 15s 1m 1m 1m 1m n/a 1m 5s-1d
LIT 1m 15s 1m 1m 1m 1m n/a 1m 5s-1d
TLT 1m 15s 1m 1m 1m 5m n/a 1m 5s-1h
STB 15s 15s 15s n/a n/a 15s n/a 20s 1s – 1m
Legend
GPS GPS acquisition interval
SBD SBD (Iridium) transmission interval
WTR Water sensor check interval
LIT Light sensor check interval
TLT Tilt sensor check interval (if Tilt is enabled)
STB Strobe Flash Interval
T0 – T7 Timer mode number
<T#> Timer currently in use
#s/m/h/d Interval in seconds/minutes/hours/days
Min Minimum allowed interval for this timer
Max Maximum allowed interval for this timer
Timers
Timer 0 Normal Used if no other modes are triggered
Timer 1 Start-up Used immediately after power-up or reset (one hour duration)
Timer 2 Surfaced Used when the device has surfaced (one hour duration)
Timer 3 Underwater Used when the device determines it is underwater
Timer 4 Low Battery Used when the device consistently detects low voltage according
to the set threshold
Timer 5 Watch
Circle Alarm Used when the device has exited its Watch Circle
•
The default timer settings of the Apollo-X are suitable for most use cases.
•
Timers 6 and 7 are not used in the Apollo-X.