Xenon 1900, User Manual

Page: 99 / 356

3 - 21
RAM Storage : The scanner will not power down while it contains data that
has not been transmitted to the base or Access Point, even if it reaches a
power down timeout. However, if the scanner runs out of battery power, it
will power down and the data will be lost.
Default = Flash Storage.
Batch Mode Quantity
When in Batch Mode, you may wish to transmit the number of multiple bar
codes scanned, rather than a single bar code multiple times. For example,
if you scan three bar codes called XYZ with
Batch Mode Quantity Off ,
when you transmit your data it will appear as XYZ three times. Using
Batch Mode Quantity On and the Quantity Codes ( page 3-22 ), you could
output your data as “XYZ, 00003” instead.
Note: If you wish to format your output, for example, place a CR or tab
between the bar code data and the quantity, refer to Data
Formatting beginning on page 6-1.
Default = Batch Mode Quantity Off.
Entering Quantities
Quantity Codes ( page 3-22 ) allow you to enter a quantity for the last item
scanned, up to 9999 (default = 1). Quantity digits are shifted from right to
left, so if a 5th digit is scanned, the 1st digit scanned is discarded and the
2nd, 3rd and 4th digits are moved to the left to accommodate the new digit.
For example, if the Quantity 5 bar code is scanned after the quantity has
been set to 1234, then the 1 is dropped, the quantity will be 2345.
RAM Storage
* Flash Storage
Batch Mode Quantity On
* Batch Mode Quantity Off