User Manual
Manx-camera
Company confidential.
This document is the property of Xenics. It may not be reproduced
–
completely or partially
–
or passed to a third
party without written permission from Xenics.
Xenics nv
T +32 16 38 99 00
Doc Ref: ENG-2019-UMN005
Ambachtenlaan 44
F +32 16 38 99 01
Issue: R003
BE-3001 Leuven
Belgium
www.xenics.com
Date: 15/05/2020
XF-104_03/20-12-2012
Page 33 of 73
Gain20_250us_<camera SN>
x20
250
Gain20_425us_<camera SN>
x20
425
Gain100_5us_<camera SN>
x100
5
Gain100_25us_<camera SN>
x100
25
Gain100_50us_<camera SN>
x100
50
Gain100_100us_<camera SN>
x100
100
Table 5-14 Factory default calibration files
Refer to Appendix C - Non Uniformity Correction (NUC)if additional calibration files are
required.
5.4.2.2
Loading calibration file via Xeneth
Ensure that the calibration files are copied to C:\Program Files\Xeneth\Calibrations or
C:\Program Files (x86)\Xeneth\Calibrations (if the 32bit Xeneth interface software was
installed on a 64bit OS).
Applicable calibration file will be shown as below. Select the required calibration file and
press connect.
Calibration files are customised for each individual camera. Files above “---” as shown in the
picture below are meant for the camera selected.
Figure 5-21 Select software calibration file
