18
14001000 XciteRC Flybarless 3D 245
14001000 XciteRC Flybarless 3D 245
EN
Getting started
Installing the flight battery
• Put the throttle stick to the lowest position.
• Turn on the transmitter.
• Install the flight battery in the battery holder, connect the battery with 4-in-1 main board, place the heli-
copter static level next to the transmitter.
• Waiting several seconds, the main rotor flap up and down twice, it means the heli successfully bind to the
transmitter. Please move the heli after the binding finished.
Troubleshooting guide
Problem
Possible cause
Solution
LED on 3-in-1 board flashes con-
stantly and operating no function
after connecting battery to heli
Transmitter is not bound to re-
ceiver
Bind transmitter to receiver.
The helicopter do not response
after connecting batteries to
receiver
Check whether the transmit-
ter and helicopter connecting
to power; check the voltage of
transmitter and helicopter´s bat-
tery; battery pole flake contact is
not good.
Open the transmitter, make sure
the batteries connecting is good;
replace and charge transmitter
batteries, make sure the battery
pole flake contact is good.
When push the throttle pole,the
rotor do not rotate and the LED
on Receiver flashes constantly.
Low battery voltage; batteries
connection is not good.
Replace and charge the
batteries,reconnect the batteries
to the receiver board.
Helicopter takes off immediately
once the batteries and helicopter
connected.
Didn´t put the throttle to the low-
est.
Put the throttle pole at thel owest
position before open the trans-
mitter.
14001000-Flybarless-3D-245-Anleitung.indd 18
24.10.2013 14:41:51
