16
14001000 XciteRC Flybarless 3D 245
14001000 XciteRC Flybarless 3D 245
EN
Getting started
Introduction
As you are about to see, the Xcite Flybarless 3D 245 truly is an ultra micro heli experience unlike any other.
Its advanced flybarless design reduces drag on the rotor head and more importantly, under the precision in
the three-axis gyroscope complement of self-control, it greatly increases stability of the body. This, combined
with its exceptionally lightweight airframe, delivers a level of power and responsiveness that eclipses that of
any ultra micro heli you have flown before.
Inverted flight, loops, lips, rolls,funnels, wash pot- the Flybarless 3D 175 can do it all, indoors or out, with
power to spare. If you‘re transitionjng from a basic CCPM or fixed pitched heli, you‘ll find the Flybarless 3D
175 is a great way to get used to flying mora agile CCPM helis without having to invest a lot in expensive
equipment or repairs.
Before you take the first flight, please take time to read through this manual. It contains important pre-flight
information as well as useful tips on binding your transmitter that will help ensure your first flight is a great one.
Helicopter Parameters
Length
238 mm
High
93,7 mm
Weight
50 g
Rotating propeller diameter
249 mm
TailRotor blade Diameter
36 mm
Battery Specification
3.7 V 300 mAh 15C
Flight time
4 to 5 min
Battery charging
• Connect charger to the USB port of computer by using USB Line.
• Connect the Li-po battery to the Charger by using Charger conversion wire, at this time, the charging
indicator light shows red. When the battery is full, the light turns green.
• The Charger can charge two batteries at the same time, and if no battery connect, the green light bright.
Notice:
Only use the charger delivered with the helicopter.
WARNING:
Never attempt to power the charger from an AC outlet without the use of a proper ACto DC
adapter/power supply. -
fire hazard!
First Flight preparation
• Make sure the battery power Is full both for TX and helicopter
• Before open the power of TX, please make sure the TH. Stick at the bottom and the switch of TH.HOLD
and 3D mode in back position (back cover direction).
• Make sure the TX is binding with helicopter, or please rebind them.
• Please open TX first, then connect the battery with the RX board on helicopter to bind with TX. When
close, please cut the power of helicopter first, and then turn off the TX.
• Flying in a suitable area, away from people, cars, electric pylon, pool and so on.
14001000-Flybarless-3D-245-Anleitung.indd 16
24.10.2013 14:41:41
