18
XciteRC Flybarless 245 Trainer V2.0
EN
Installing the Flight Battery
Installing the flight battery
•
Put the throttle stick to the lowest position.
• Turn on the transmitter. Check the model memory (please see first flight preparation).
• Install the flight battery in the battery holder, connect the battery with 4-in-1 main board, place the heli-
copter static level next to the transmitter.
• Waiting several seconds, the main rotor flap up and down twice, it means the heli successfully bind to the
transmitter. Please move the heli after the binding finished.
Troubleshooting guide
Problem
Possible cuase
Solution
LED on 3-in-1 board flashes con-
stantly and operating no function
after connecting battery to heli-
copter.
Transmitter is not bound to re-
ceiver.
Bind transmitter to receiver.
The helicopter do not response
after connecting batteries to re-
ceiver.
Check whether the transmit- ter
and helicopter connecting to po-
wer; check the voltage of trans-
mitter and helicopter‘s bat- tery;
battery pole flake contact is not
good.
Open the transmitter, make sure
the batteries connecting is good;
replace and charge transmitter
batteries, make sure the battery
pole flake contact is good.
When push the throttle pole,the
rotor do not rotate and the LED
on Receiver flashes constantly.
Low battery voltage; batteries
connection is not good.
Replace and charge the batte-
ries, reconnect the batteries to
the receiver board.
Helicopter takes off immediately
once the batteries and helicopter
connected.
Didn‘t put the throttle to the low-
est.
Put the throttle pole at the lowest
position before open the trans-
mitter.
