16
XciteRC Flybarless 245 Trainer V2.0
EN
Getting started
Introduction
As you are about to see, the Xcite
Flybarless Trainer 245 V2.0
truly is an ultra micro heli experi-
ence unlike any oth er. Its advanced flybarless design reduces drag on the rotor head and more im-
portantly, under the precision in the three-axis gyroscope complement of self-control, it greatly in-
creases stability of the body. This, com
bined with its exceptionally lightweight airframe, delivers a
level of power and responsiveness that eclipses that of any ultra micro heli you have flown before.
Before you take the first flight, please take time to read through this manual. It contains important pre-flight
information as well as useful tips on binding your transmitter that will help ensure your first flight is a great one.
Specifications
Length
283 mm
High
93.7 mm
Weight
48 g
Main blades length
113 mm
Main blade diameter
249 mm
Tail rotor diameter
36 mm
Battery
3.7 V 300 mAh 15C
Flight time
approx. 5 - 6 minutes
Battery charging
NOTE:
Only use the charger delivered with the helicopter.
WARNUNG:
Never attempt to power the charger from an AC outlet without the use of a proper AC/
DC adapter/power supply
- fire hazard!
• Connect charger to the USS port of computer by using USB Line.
• Connect the Li-po battery to the Charger by using Charger conversion wire, at this time. the charging
indicator light shows red. When the battery is full, the light turns green.
• The Charger can charge two batteries at the same time, and if no battery connect, the green light bright.
First Flight preparation
Make sure the battery power is full for both transmitter and helicopter.
WARNING:
check the selected model memory of your XRC-6S transmitter, „HFP“ is the correct me-
mory - otherwise the model may react uncontrollable at your commands -
crash hazard!
For changing
the model memory please read the transmitters manual.
• Before open the power of TX, please make sure that the TH. Stick is in bottom position and the switch of
TH.HOLD and 3D mode in back position (back cover direction).
• Make sure the TX is binding with helicopter, or please rebind them.
• Please switch on the transmitter first, then connect the battery with the RX board on helicopter to bind
with the transmitter. When switching off, please cut the power of helicopter first, and then turn off the TX.
•
ATTENTION:
please pay attention to the saftey instructions at the beginning of this manual! Flying
in a suitable area, away from people, cars, electric pylon, pool and so on.
