User manual XC-32 XC-320 XC-4200
192.168.1.0 192.168.2.1 255.255.255.255 net eth0
The third, (and most often used manner) consists in informing Xcell that, if the routing
table does not contain any entry corresponding to the IP frame to send, then this one will
be sent (by default) to the
192.168.2.1
router :
ROOT>> route add net eth0 0.0.0.0 192.168.2.1 0.0.0.0
Ok!
ROOT>> route static
Kernel routing table
Destination Gateway Genmask Typ Iface
192.168.2.0 0.0.0.0 255.255.255.0 net eth0
0.0.0.0 192.168.2.1 0.0.0.0 net eth0
IV.5 - Asynchronous interfaces
IV.5.1 - Software settings
Configuration of a serial port can be done with
serial
command :
You must enter individually each parameter :
ROOT>> serial speed 9600 4
ROOT>> serial csize 8 4
ROOT>> serial parity none 4
ROOT>> serial stopb 1 4
Port 4 can then be setup to 9600 bauds, without parity control, with a 8 bits data width and
one stop bit.
To set the port speed of ports 3, 6 and 7 to 19200 bps, type the following command :
ROOT>> serial speed 19200 3 6 7
To set all ports to 38400 bps, enter the following command :
ROOT>> serial speed 38400 all
To set all ports but ports 3 and 5 to 4800 bps, enter :
ROOT>> serial speed 4800 all 3 5
You can see, at every time, all current ports parameters with the following command :
ROOT>> serial show all
-21-