31
VIPER MIG 165
OPERATING MANUAL
13. MIG: Changing Your Torch Liner (Aluminium)
1.
Remove MIG torch front end parts.
2.
Remove the liner retaining nut.
3.
Carefully pull out and completely remove the existing
liner. Ensure MIG torch is completely unravelled until
setup is complete.
4.
Fit the neck spring to the front end of the aluminium
liner.
5.
Feed liner and neck spring through the torch, then fit
liner collet, liner O-ring and liner retaining nut.
6.
Push the liner firmly into the torch lead and tighten the
liner retaining nut.
